Для справки.
Страница 427, 2001-3_pt_cruiser_service_manual.pdf
"HEADLAMP UNIT ALIGNMENT
A properly aimed low beam headlamp will project a high intensity light pattern on the screen with the horizontal cut-off line aligned with the tape line 100 mm (3.94 in.) below the headlamp centerline (Fig. 14). The intersection of the horizontal and 15 degree cut-off lines in the projected pattern should align to the intersection of the headlamp centerline vertical tape line and the tape line 100 mm (3.94 in.) below the headlamp horizontal centerline. The high beams on a vehicle with aero headlamps cannot be aligned. The high beam pattern should be correct when the low beams are aligned properly.
To adjust headlamp unit alignment, rotate the alignment screws (horizontal and vertical)to achieve the specified low beam spot pattern. The alignment screws are located in the front of the head*lamp unit, just below the lens."
Перевод ПРОМТ:
"ВЫРАВНИВАНИЕ ЕДИНИЦЫ ФАРЫ, Чтобы приспособить выравнивание единицы фары, вращайте винты выравнивания (горизонтальный и вертикальный), чтобы достигнуть указанного низкого образца пятна луча. Винты выравнивания расположены перед единицей фары, только ниже линзы."
:book: